How the spindle works
The working principle of the spindle is usually in the needle rise a certain distance, the tip of the spindle bed begins to hook into the ring, the tip hook the ring and continue to rotate, when the ring is sent to the spindle frame rail guide mouth, the ring is hooked by the shuttle frame hook, then the needle should rise about 2 mm from the lower limit position. The wire hook on the shuttle frame should be close to the online ring, the end of the ring leave time to move behind the rail, wire hook and needle movement axis Angle is about 50, by the shuttle bed shuttle tip outside the frame convex above 45 hook the ring, continue to turn, the end of the wire ring hook on the end, the end of the wire ring to face outside, and the back of the wire ring by the wire hook hook, slide at the bottom of the shuttle frame, at this moment, the needle in the shuttle mechanism.
Because the shuttle frame line is very smooth, make the ring smoothly from the bottom of the shuttle slide out, can make the shuttle tip turned 180, pick rod rise, the rest of the line, the shuttle tip hook the wire to continue to rotate, the front half under the wire plate, through the frame convex 45 inclined plane, after moving wire plate edge, gradually above the shuttle, the front half of the ring to the outside. The second half of the ring is hooked by the sub-hook of the shuttle frame, and the ring is separated, and finally, the ring is set by the front and back of the shuttle frame, the bottom line is set in the middle, and the ring is tightened by the pick rod to form a line track.
The operation cycle of the shuttle mechanism between 203 ~312 is the stage of catching the loop and expanding the loop, and between 312 ~320 is the needle exit from the spindle sleeve gap stage 0 ~180 is the empty stroke. The upper axis one turn, the spindle two turn, and the effect in the second turn.
The principle of the formation of the spindles is basically the same as that of the spindles, but the process and method of the formation are different: the spindle is the rotation of the spindle is rotating; in a reciprocating movement (the spindle rotates), the spindle is rotated at the angular speed of the spindle and the rotation of the spindle rotates once.
Because the shuttle frame line is very smooth, make the ring smoothly from the bottom of the shuttle slide out, can make the shuttle tip turned 180, pick rod rise, the rest of the line, the shuttle tip hook the wire to continue to rotate, the front half under the wire plate, through the frame convex 45 inclined plane, after moving wire plate edge, gradually above the shuttle, the front half of the ring to the outside. The second half of the ring is hooked by the sub-hook of the shuttle frame, and the ring is separated, and finally, the ring is set by the front and back of the shuttle frame, the bottom line is set in the middle, and the ring is tightened by the pick rod to form a line track.
The operation cycle of the shuttle mechanism between 203 ~312 is the stage of catching the loop and expanding the loop, and between 312 ~320 is the needle exit from the spindle sleeve gap stage 0 ~180 is the empty stroke. The upper axis one turn, the spindle two turn, and the effect in the second turn.
The principle of the formation of the spindles is basically the same as that of the spindles, but the process and method of the formation are different: the spindle is the rotation of the spindle is rotating; in a reciprocating movement (the spindle rotates), the spindle is rotated at the angular speed of the spindle and the rotation of the spindle rotates once.
